Nowadays, research in the field of metal oxide nanoparticles is proceeding vigorously . ZnO has attracted intensive research effort for its unique properties and versatile applications in ultraviolet (UV) light emitters, short-wavelength nano-lasers, and piezoelectric devices, ultrasensitive, spin electronics, field-effect transistors, and field emitters. ZnO is a typical n-type semiconductor, in which the density of holes in the valence band is exceeded by the density of electrons in the conduction band; the major charge carrier in ZnO semiconductors is electrons in the conduction band. Zinc oxide nanoparticles are used in various applications of catalyst , photocatalyst , U-V absorption and antibacterial treatment . Zinc oxide is a wide band gap semiconductor with a band gap of 3.37 eV. Pure nonstoichiometric ZnO is n-type semiconductor. Its optical and electrical properties are not very stable at high temperature . It is used for high power devices, ferroelectric memories, transparent conductive films used in displays, solar cells, various optoelectronic devices [6-8] and gas sensors [9- 16]. ZnO based material have been widely used as dielectric, ceramics, pigments, catalyst and sensing materials . ZnO thin films have been grown using several deposition techniques, such as: spray pyrolysis , magnetron sputtering [19, 20], pulsed laser deposition [21, 22], chemical vapor deposition [23, 24] and sol-gel techniques .
Currently, there is a great interest in the methods of creating nanostructures on the surfaces for the next generation high performance nano-devices and for the number of molecular electronics applications. Therefore, synthesis and characterization of the nanostructured ZnO thin films and nanocrystalline powder have been an active area of research for nearly half a century and is still an active area of high priority research in nanoscale research [26-28]. ZnO exists in variety of nanostructures. Therefore, it is expected that it will be the next most important nanomaterial after the carbon tubes. In the present work, nanostructured ZnO thin films were prepared by sol- gel dip-coating technique and characterized by various analytical techniques.
MATERIALS AND METHODS
Zinc acetate [(CH3COO)2 Zn.2H2O GR grade] and ethanol was used as precursor materials. 0.2 M zinc acetate was dissolved in 50 ml ethanol under vigorous stirring at 800C. This solution was refluxed for 3 hours and then cooled to a room temperature as explain elsewhere . Ammonium hydroxide (NH4OH) was drop-wise added to obtain the sol-gel of different pH (varying from 6.9 to 7.2). ZnO thin films were obtained by dipping the glass substrates and then dried in air at room temperature. This process was repeated for different number of coats (dipping cycles) for the typical sol. ETCL –01 dip coater was used for coating the films. The films, so obtained were annealed at 5000C. The sol-gel was washed and dried at 5000C to obtain ZnO powder.
The possible chemical reactions responsible to form ZnO could be represented as follows:
Zn(OH)2 → ZnO + H2O (1b)
Addition of ammonium hydroxide into zinc acetate would result into ammonium acetate and zinc hydroxide (Eq.1 (a)). Heat treatment would convert zinc hydroxide into ZnO (Eq.1 (b)).
The overall chemical reaction can be written as:
Zn(CH3COO)2 + 2NH4OH → ZnO + 2CH3COO NH4 + H2O (2)
ZnO powder and films could therefore be obtained successfully prepared by sol-gel dip-coating technique.
As prepared ZnO powder was examined by Philips X-ray diffractometer (Model PW 1730). The surface morphologies of the films were studied by JEOL 6300(LA). The quantitative elemental analysis of the films was carried out by using JEOL-energy dispersive spectrometer (Model JED-2300). The transmission electron microscopy of the film was studied by Tecnai 20 G2 (FEI make).
RESULTS AND DISCUSSION
Fig. 1. shows the x-ray diffractogram of the powder after drying the gel. The diffraction peaks from various planes and d values, as represented in Table 1, are matching well with reported JCPDS data for ZnO which confirmed the powder to be of ZnO. The confirmation of the ZnO powder, in turn, would confirm that the material deposited on substrate to be of ZnO.
Scherrer’s formula for grain size calculation
t = 0.9 λ/β cos θ (3)
Where, λ = Wavelength of X-ray, β = FWHM of peak, cos θ = Corresponding angle of the peak.
The average grain size calculated from Scherrer’s formula was about 27 nm.
Elemental analysis by EDAX
Fig. 2 shows the energy dispersive spectra of the sample prepared with 5 coats and pH = 7.1. The mass% of Zn and O in stoichiometric ZnO (at% of each of Zn and O is 50) are expected to be 80.3 and 19.7 respectively. The observed values of mass % of Zn and O are represented in Table 2.
The elemental composition from Table 2, clearly indicates that the films are nonstoichiometric in nature. The films are observed to be zinc deficient.
Surface morphology using SEM
Effect of coating on particle size
Fig. 3(a), (b) and (c) are the SEM images of the thin films obtained after 5, 6 and 7 coats respectively from pH 7.1. The average particle sizes were observed from SEM image is presented in Table 3. The particle size distribution was observed to be reasonably narrow.
It is clear, from Table 3 that as the particle sizes increases with increase in number of coats.
Effect of pH on particle size and morphology
Fig. 4. (a), (b) and (c) show the SEM images of the film samples 1, 2 and 3 obtained from solutions with pH 6.9, 7.1 and 7.2 respectively. The average particle sizes of the films with pH 6.9, 7.1 and 7.2 were observed to be: 29.8 nm, 30.6 nm and 30.0 nm respectively. The particle size distribution seems to be reasonably narrow. The SEM images clearly indicate the elliptical or spherical shaped nanoparticles.
Microstructure using TEM
Fig. 5 shows the transmission electron microscopy image of the sample prepared with 5 coats and pH = 7.1. It is clear from TEM image that there are uniformly distributed spherical-shaped grains with the average grain size of 25 nm.
ZnO films obtained from sol-gel dip-coating technique were observed to nanostructured. The average grain size calculated from Scherrer’s formula was about 27 nm. Average particle size was observed from SEM is to be smaller than 40 nm. The average grain size observed from TEM was about 25nm. The most of the particles were observed to be spherical in shape. ZnO films were observed to be nonstoichiometric (Zinc deficient) in nature. Number of coats used to synthesize the films was increase with increase in size of nanostructured ZnO.
The authors are thankful to the Head, Department of Physics and Principal, Arts, Commerce & Science College, Bodwad.
CONFLICT OF INTEREST
The authors declare that there are no conflicts of interest regarding the publication of this manuscript.
2. Huang W-J, Fang G-C, Wang C-C. A nanometer-ZnO catalyst to enhance the ozonation of 2,4,6-trichlorophenol in water. Colloids and Surfaces A: Physicochemical and Engineering Aspects. 2005;260(1-3):45-51.
5. Bari A R, Sawadekar N P, Bari P A, Bari R H, Suryawanshi D N, Pathan I G, Patil L A. Synthesis and characterization of zinc oxide nanowires, Int. Jn. Chem.and Phy. Sci., 2018; 7: 371-374.
6. Shionoya S, Yen W M, Phosphor Handbook (CRC Press, Boca Raton, 1999), p. 255.
8. Tang Z K, Wang G K, Yu L P, Kawasaki M, Ohtomo A, Koinuma H, Appl. Phys. Leet., 1997; 70: 2230.
9. Zang Q, Xie C, Zange S, Wang A, Zhu B, Wang L, Yang Z. Sens. Actuators B., 2005; 110: 370-376.
10. Lin H M, Tzeng S J, Hsiau P J, Tsia W L. Nano Struct. Mater. 2005; 10: 370.
11. Patil LA, Bari AR, Shinde MD, Deo V, Kaushik MP. Detection of dimethyl methyl phosphonate – a simulant of sarin: The highly toxic chemical warfare – using platinum activated nanocrystalline ZnO thick films. Sensors and Actuators B: Chemical. 2012;161(1):372-80.
13. Bari AR, Patil LA, Pathan IG, Surawanshi DN, Rane DS. Characterizations of Ultrasonically Prepared Nanostructured ZnO powder and NH 3 Sensing Performance of its Thick Film Sensor. Procedia Materials Science. 2014;6:1798-804.
19. Nakada T, Ohkubo Y, Kunioka A. Effect of Water Vapor on the Growth of Textured ZnO-Based Films for Solar Cells by DC-Magnetron Sputtering. Japanese Journal of Applied Physics. 1991;30(Part 1, No. 12A):3344-8.
21. Hiramatsu M, Imaeda K, Horio N, Nawata M. Transparent conducting ZnO thin films prepared by XeCl excimer laser ablation. Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films. 1998;16(2):669-73.
22. Sing A V, Mehera R M, Yoshida A, Wakahara A, J. Appl. Phys., 2001; 90: 5661.
24. Minami T, Sato H, Takata S, Ogawa N, Mouri T. Large-Area Milky Transparent Conducting Al-Doped ZnO Films Prepared by Magnetron Sputtering. Japanese Journal of Applied Physics. 1992;31(Part 2, No. 8A):L1106-L9.
25. Bari A R, Shinde M D, Deo V, Patil L A, Effect of solvents on the particle morphology of nanostructured ZnO, Ind. J. Pure & Appl. Phys., 2009; 47: 24-27.
26. Patil LA, Bari AR, Shinde MD, Deo V, Kaushik MP. Effect of precursor concentrations on structural, microstructural and optical properties of nanocrystalline ZnO powder synthesized by an ultrasonic atomization technique. Physica Scripta. 2010;82(3):035601.
27. Patil LA, Bari AR, Shinde MD, Deo V. Effect of pyrolysis temperature on structural, microstructural and optical properties of nanocrystalline ZnO powders synthesised by ultrasonic spray pyrolysis technique. Journal of Experimental Nanoscience. 2011;6(3):311-23.